354 - Sprayer setupGeneral infoUnloading the Sprayer from the TruckFor the unloading of the sprayer, you need a crane. When unloadingwith a crane please observe the lifting points as shown in the picture,and make sure that the straps or belts used for lifting are strong enough.μ ATTENTION! Only lift the sprayer when the tanks are empty!Pulling the Sprayer at the Tie Down PointsFor moving the sprayer or loading it onto e.g. a truck, it can be pulled inthe tow hitches or pulling eyes at the rear-end (A), or a hook can befastened into the hole in the front end of the sprayer (B) as shown.Before Putting the Sprayer into OperationAlthough the sprayer has been supplied with a strong and protective surface treatment on steel parts, bolts etc. in thefactory, it is recommended to apply a film of anticorrosion oil (e.g. CASTROL RUSTILO or SHELL ENSIS FLUID) on all metal partsin order to avoid chemicals and fertilizers discolouring the enamel.If this is done before the sprayer is put into operation for the first time, it will always be easy to clean the sprayer and keepthe enamel clean for many years. This treatment should be carried out every time the protection film is washed off.