6 - Maintenance82250 Hours Service - Inspect Parking Brake (optional)Inspect the following:Parking brake leverIf it can be pulled further backwards than 90° (midway), using a tractionof approximately 25 kg, the cable needs to be adjusted.Parking brake cableInspect the parking brake cables for possible wear or damages. Replaceworn or damaged parts.When the parking brake is relieved, the cable must be limp; otherwise itneeds to be adjusted.Correct length:• When the brake is relieved, the cable must be tight and yet notstretched.• Lengthening/shortening of the parking brake cable is carried outby adjusting the turnbuckle located inside the frame.μ ATTENTION! There are two versions of the hand brake systemavailable. One version is connected to the centre of the wheelaxle (see picture to the right), the other version is connected nearthe wheel.1. Once the brake lever (A) is adjusted, tighten the cable by moving the hand brake lever (B) back.2. Tighten the bolts on the brake connector (C).3. Fine-tuning of the hand brake can be adjusted with the cable bolt (D).250 Hours Service - Brake Adjustment (optional)Lift the back of the sprayer from the ground. It is recommended to usetwo lifting jacks, which are placed under the wheel axle. Make sure thesprayer is stable and secured before carrying out any adjustments.μ ATTENTION! There are two versions of the hand brake systemavailable, one of the pictures should show your system at hand.1. Loosen the 4 bolts at the brake connector (C) between the brakearms. Also loosen the screw in each end of the brake connectorand the hand brake cable.2. Adjust the nut (A) counterclockwise. Turn the nut 60° (1/6 turn) at a time - alternately on both left and right brake.Continue the adjustment, until resistance occurs when rotating the hub/wheel.3. Turn the nut 60° (1/6 turn) clockwise to loosen brake. Hub/wheelshould rotate freely now.4. Tighten the brake connector (C) bolts again.5. Tighten the hand brake cable again - See “250 Hours Service -Inspect Parking Brake (optional)” on page 82.± WARNING! The adjustment must be carried out simultaneouslyon both brakes. Therefore, adjust both left brake and right brakealternately.
