6 - Maintenance89Alignment of 1st outer and 2nd outer wingsThe 2nd outer wings must be aligned with the 1st outer wings. Ifnecessary adjust the 2nd outer wings as follows:1. Depressurize the folding cylinders.2. Loosen counter nuts (A) and (C).3. Loosen the screws (B).4. Adjust the rigging screw (D), until the nozzle sections are alignedwith each other.5. Adjust the stop screws (B) up against the inner section.6. Tighten counter nuts again.7. Check the alignment. If needed, redo the adjustment describedabove.μ ATTENTION! The rigging screw (D) must be slightly overtightened/adjusted to insure a firm and fixed outer section.Breakaway section adjustmentThe breakaway section must release when a force of approximately 150N (15 kg) is applied to the extremity of the breakaway section. Ifnecessary, the release force is adjusted as follows:1. Make sure that claw coupling is correctly lubricated.2. Loosen the counter nut (A).3. Adjust the nut (B), until the breakaway will release at a force of 150N (15 kg) applied at the extremity of the section.4. Tighten the counter nut again.€ DANGER! Never place fingers into open breakaway clutch! Youmay be injured, if the clutch snap closes by accident!± WARNING! Do not tighten the breakaway clutch more than necessary. Over-tightening can cause damage to theboom.End stop valvesThe end stop valve activates/disables the folding/unfolding of theboom.Inspect with the 1st and 2nd outer wings in folded position, and withthe 1st outer and inner wing sections in folded position. The distancebetween the bolt head (A) and the surface (B) of the cylinder is 3 mm.Adjust position of bolt (A) if necessary.BA
