IBM 88631SU - System x3850 - 8863 Installation Manual

Also see for 8863 - eServer xSeries 366: Service guide Service guide Installation guide Problem determination and service guide

Contents

d. Close the tray levers and make sure they are securely latched.e. Close the microprocessor-tray release latch.f. Reinstall the fans and memory cards in the server.If you have other options to install or remove, do so now; otherwise, go to“Completing the installation” on page 23.Installing an adapterThe following describes how to install adapters in the server.Installing the Remote Supervisor Adapter II SlimLineThe optional IBM Remote Supervisor Adapter II SlimLine must be installed in itsdedicated connector on the I/O board. The following illustration shows how to installthe Remote Supervisor Adapter II SlimLine.I/O boardRemote Supervisor Adapter II SlimLineRemote Supervisor Adapter II SlimLine connectorStandoffStandoffComplete the following steps to install a Remote Supervisor Adapter II SlimLine.1. Insert the rear 1of the adapter into the rear standoff; then, rotate the front2of the adapter into the front standoff.2. Press the Remote Supervisor Adapter II SlimLine firmly into the connector.Installing a ServeRAID-8iIf you are installing an optional ServeRAID-8i, review the following information:v The ServeRAID-8i can be installed only in a dedicated slot on the PCI-X board.v The ServeRAID-8i adapter is not cabled to the server and no rerouting of theSAS cables is required.20 IBM System x3850 Type 8863: Installation Guide