| 
– rebootForce the server to restart.– sel getDisplay the BMC system event log.– solConfigure the SOL function.– sysinfoDisplay system information that is related to the server and the globallyunique identifier (GUID).Using the SAS/SATA Configuration Utility programTo start the SAS/SATA Configuration Utility program, complete the following steps:1. Turn on the server.2. When the prompt <<< Press for Adaptec SAS/SATA ConfigurationUtility! >>> appears, press Ctrl+A.3. To select a choice from the menu, use the arrow keys.4. Follow the instructions on the screen to change the settings of the selecteditems, and press Enter.Using the ServeRAID configuration programsA ServeRAID controller enables you to configure multiple physical hard disk drivesto operate as logical drives in a disk array. The controller comes with a CDcontaining the ServeRAID Manager program and the ServeRAID Mini-Configurationprogram, which you can use to configure the ServeRAID controller. For informationabout these programs, see the documentation that comes with the ServeRAIDcontroller and the User’s Guide on the IBM Documentation CD. If your servercomes with an operating system installed, such as Microsoft Windows 2000Datacenter Server, see the software documentation that comes with the server forconfiguration information.Using the PXE boot agent utility programThe Preboot Execution Environment (PXE) boot agent utility program is part of theBIOS code. You can use it to specify the startup order of devices and enable ordisable operating-system wake-up support.Note: The server does not support changing the network boot protocol orspecifying the startup order of devices through the PXE boot agent utility program.Complete the following steps to start the PXE boot agent utility program:1. Turn on the server.2. When the Initializing Intel (R) Boot Agent Version X.X.XX PXE 2.0 BuildXXX (WfM 2.0) prompt appears, press Ctrl+S. You have 2 seconds (by default)to press Ctrl+S after the prompt appears. If the prompt does not appear, use theConfiguration/Setup Utility program to enable the Ethernet PXE/DHCP option.3. Use the arrow keys and press Enter to select a choice from the menu.4. Follow the instructions on the screen to change the settings of the selecteditems; then, press Enter.44 IBM System x3850 Type 8863: Installation Guide |
