iSeriesiSeries Access for WindowsOperations ConsoleERserver

IBM E Server i Series Manual

data integrity and verification

laser safety information

environmental design

who should read this book

expansion unit

Plan your cable layout

Redundant links

System unit cable options

Configuration rules

HSL loop addressing

Installing the 7002 cable

Chapter 2. Set up your expansion unit

Examples of HSL Connections

Connect your unit with SPCN cables

Examples SPCN Connections

Chapter 3. Complete your installation

Chapter 4. Verify your new configuration

Appendix A. Remove or open the back covers

back cover

and 5294 back cover

and 890 back cover

Accessing units in a rack

Appendix B. Connector locations

and 810 HSL connector locations

HSL connector locations

and 890 HSL connector locations

connector locations

or 0578 connector locations

Appendix C. System unit control panel

Notices

Trademarks

Electronic Emission Notices

E Server i Series

Chapter 1. 43xx or 71xx disk unit

Chapter 2. Replace 43xx disk units

Replace 43xx RAID or Mirrored protected disk units with system powered off

Chapter 3. Install 43xx disk units

Details: Install 43xx disk units with system power on

Install 43xx disk units with system power off

Details: Install 43xx disk units with system power off

Open or remove the front cover

front cover

or 5095

Disk unit locations

or 7116 expansion unit

system unit

and 5094 expansion unit

and 5095 expansion unit

and 5294 expansion unit

System-unit control panel

server or 7116 expansion unit to the 800 or 810 server

Install the 7123 or 7136 disk unit enclosure

Install the 7124 or 7127 disk unit enclosure

Install the power supply

Power down the system unit

Remove the side and back cover

Appendix. Notices

Terms and conditions for downloading and printing publications

Code disclaimer information

Chapter 1. Preparing to set up your

Identifying HSL and SPCN Cables

Powering down your iSeries system unit

Chapter 2. Setting up your

Connecting your 5074 to another expansion unit

Connecting your 5074 at the beginning of a loop

Connecting your 5074 to the middle of a loop

Connecting your 5074 to the end of a loop

Chapter 3. Setting up your

Chapter 4. Setting up your

Connecting your 5079 to another expansion unit

Connecting your 5079 in the middle of a loop

Connecting your 5079 to the end of a loop

Chapter 5. Completing your installation

Chapter 6. Verifying Your New Configuration

Appendix A. Removing the back covers

and 840 back cover

Appendix B. Connector Locations

with a migration unit or the 9079 and 9094 expansion unit