IBM System x3250 Installation Manual

Also see for System x3250: Installation and user guide User guide Specifications Problem determination and service guide

Contents

Chapter 2. Installing optional devicesThis chapter provides basic instructions for installing optional hardware devices inthe server. These instructions are intended for users who are experienced withsetting up IBM server hardware.Installation guidelinesBefore you install optional devices, read the following information:v Read the safety information that begins on page v and the guidelines in“Handling static-sensitive devices” on page 8. This information will help you worksafely.v When you install your new server, take the opportunity to download and applythe most recent firmware updates. This step will help to ensure that any knownissues are addressed and that your server is ready to function at maximum levelsof performance. To download firmware updates for your server, go tohttp://www.ibm.com/servers/eserver/support/xseries/index.html, select Systemx3250 from the Hardware list, click Go, and then click the Download tab. Foradditional information about tools for updating, managing, and deployingfirmware, see the System x and xSeries Tools Center at http://publib.boulder.ibm.com/infocenter/toolsctr/v1r0/index.jsp.v Before you install optional hardware devices, make sure that the server isworking correctly. Start the server, and make sure that the operating systemstarts, if an operating system is installed, or that a 19990305 error code isdisplayed, indicating that an operating system was not found but the server isotherwise working correctly. If the server is not working correctly, see Chapter 5,“Solving problems,” on page 29 for diagnostic information.v Observe good housekeeping in the area where you are working. Place removedcovers and other parts in a safe place.v If you must start the server while the cover is removed, make sure that no one isnear the server and that no tools or other objects have been left inside theserver.v Do not attempt to lift an object that you think is too heavy for you. If you have tolift a heavy object, observe the following precautions:– Make sure that you can stand safely without slipping.– Distribute the weight of the object equally between your feet.– Use a slow lifting force. Never move suddenly or twist when you lift a heavyobject.– To avoid straining the muscles in your back, lift by standing or by pushing upwith your leg muscles.v Make sure that you have an adequate number of properly grounded electricaloutlets for the server, monitor, and other devices.v Back up all important data before you make changes to disk drives.v Have a small flat-blade screwdriver available.v You do not have to turn off the server to install or replace hot-plug UniversalSerial Bus (USB) devices.v Blue on a component indicates touch points, where you can grip the componentto remove it from or install it in the server, open or close a latch, and so on.v Orange on a component or an orange label on or near a component indicatesthat the component can be hot-swapped, which means that if the server andoperating system support hot-swap capability, you can remove or install the© Copyright IBM Corp. 2007 7