IBM ThinkPad 340 Series Hardware Maintenance Manual

Also see for 360: Specifications Hardware Maintenance Manual Operating guide User guide Manual

Set Startup Sequence1. Power-off the computer.2. Insert the backup copy of the Reference Diskette intothe diskette drive.3. Power-on the computer.4. Select Set features from the Main Menu.5. Select Set startup sequence. If you cannot set thestartup sequence, replace the system board.6. Check the list of devices on the Set startupsequence screen.7. Is the hard disk drive in the list as a startup device?Yes Exit from this screen and the Main Menu.Remove the backup copy of the ReferenceDiskette, and power-off the computer.Continue with step 8.No Add the hard disk drive as a startup device.8. Is an operating system installed?Yes Go to step 10.No Install the operating system.9. After the operating system is installed, power-off thecomputer.10. Power-on the computer.Note: After the programs have been restored, theDiskette and F1 prompts appear, unless anoperating system is present.Restore System PartitionIf the above sequence does not correct the problem, dothe following:1. Power-off the computer.2. Insert the backup copy of the Reference Diskette intothe diskette drive.3. Power-on the computer.Note: If the I99900X5 error message appears, thepower-on password has been set. To disablethe power-on password (see “Power-OnPassword (700, 700C)” on page 97) beforecontinuing with the next step.4. Select Backup/Restore system programs from theMain Menu, then select Restore the SystemPartition.5. When the restore process completes, select Setconfiguration, then select Run automaticconfiguration.6. Power-off the computer and remove the backup copyof the Reference Diskette from the diskette drive.7. Power-on the computer.98 IBM Mobile Systems HMM