IBM eServer 220 xSeries Installation Manual

Also see for 220: Service guide Configuration and options guide Hardware Maintenance Manual

Contents

14 IBM® xSeries 220: Installation GuideInstalling an adapterNote: The illustrations in this document might differ slightly from your hardware.Attention: When you handle electrostatic discharge (ESD) sensitive devices, takeprecautions to avoid damage from static electricity. For details on handling thesedevices, see “Handling static sensitive devices” on page xi.To install an adapter, do the following:1. Review the safety precautions in “Safety” on page v.2. Turn off the server and peripheral devices and disconnect all external cables andpower cords.3. Remove the cover (see “Removing the side cover” on page 10 for details).4. Carefully remove the support bracket assembly from the server (see “Removingthe support bracket assembly” on page 10). Store the cover and the supportbracket assembly in a safe place.5. Determine which expansion slot you will use for the adapter.Note: Check the instructions that come with the adapter for any requirementsor restrictions.6. Remove the rear adapter retaining bracket from the server. If you are installing afull-length adapter, rotate the front adapter support bracket to the open(unlocked) position.7. Remove the expansion-slot cover. Store it in a safe place for future use.Attention: Expansion-slot covers must be installed on all vacant slots. Thismaintains the electronic emission characteristics of the system and ensures propercooling of system components.Rear adapterretainingbracketFront adaptersupportbracketAdapterExpansion-slotcover