operating-system event logs. You can view the DSA event log through the DSAprogram (see “Viewing event logs without restarting the server”). For moreinformation about DSA and DSA messages, see “IBM Dynamic System Analysis”on page 149 and Appendix C, “DSA diagnostic test results,” on page 693.Viewing event logs through the Setup utilityUse this information to view event logs through the Setup utility.About this taskTo view the POST event log or system-event log, complete the following steps:Procedure1. Turn on the server.2. When the prompt Setup is displayed, press F1. If you have set both apower-on password and an administrator password, you must type theadministrator password to view the event logs.3. Select System Event Logs and use one of the following procedures:v To view the POST event log, select POST Event Viewers.v To view the system-event log, select System Event Log.Viewing event logs without restarting the serverIf the server is not hung and the IMM is connected to a network, methods areavailable for you to view one or more event logs without having to restart theserver.If you have installed Dynamic System Analysis (DSA) Portable, you can use it toview the system-event log (as the IPMI event log), or the IMM event log (as theASM event log), the operating-system event logs, or the merged DSA log. You canalso use DSA Preboot to view these logs, although you must restart the server touse DSA Preboot. To install DSA Portable or check for and download a laterversion of DSA Preboot CD image, go to http://www.ibm.com/support/entry/portal/docdisplay?lndocid=SERV-DSA.If IPMItool is installed in the server, you can use it to view the system-event log.Most recent versions of the Linux operating system come with a current version ofIPMItool. For an overview of IPMI, go to http://www.ibm.com/developerworks/linux/blueprints/ and click Using Intelligent Platform Management Interface(IPMI) on IBM Linux platforms.You can view the IMM event log through the Event Log link in the integratedmanagement module II (IMM2) web interface. For more information, see “Loggingon to the web interface” on page 117.The following table describes the methods that you can use to view the event logs,depending on the condition of the server. The first three conditions generally donot require that you restart the server.Chapter 4. Troubleshooting 147
