IDS 816 Installer Manual

Also see for 816: User manual User manual

IDS 816 Installer Manual Manual pdf 17 page image

IDS 816 700-283-02I Issued September 200917To read the data stored in multi-digit locations (e.g. a telephone number, account codes, etc.),enter the location. Upon initial entry into the location, the zone indicators will display the first digit.Pressing the [Panic] key will cause the next digit within the location to be displayed.Where a hexadecimal number must be programmed, use the [MODE] key as per Table 2 below:Table 2 : Hexadecimal ValueHex Value Decimal Value Key StrokesA 10 [MODE] key then [0] keyB 11 [MODE] key then [1] keyC 12 [MODE] key then [2] keyD 13 [MODE] key then [3] keyE 14 [MODE] key then [4] keyF 15 [MODE] key then [5] key7.1 Entering Program Mode1. Ensure that all partitions are unarmed.2. Press the [#] hash key followed by the [INSTALLER CODE].3. The default installer code is 9999 or alternatively 999999 should a six digit default installer codehave been used.4. Press the [*] star key and a long beep will confirm entry into program mode. If a correct codehas been entered, the green READY indicator will flash.7.2 Programming Standard Locations1. Ensure the panel is in program mode - the READY indicator will be flashing.2. Enter the [LOCATION NUMBER] of the program location you wish to view or change.3. Press the [*] star key. The READY indicator will continue flashing and the AWAY indicator willcome on.4. The zone LED’s will display the data stored in the program location in binary format.5. Enter the [NEW DATA] followed by the [*] star key. A long beep will indicate a valid entry and theAWAY indicator will turn off.6. If you do not wish to change the data, press the [#] key. The READY indicator will continueflashing and the AWAY indicator will turn off.7. Repeat steps 2 - 6 until all the necessary locations have been programmed.8. Press the [#] hash key to exit program mode.9. The READY indicator will stop flashing and the panel will return to the standby mode.7.3 Programming Extended Locations1. Ensure that the panel is in program mode - the READY indicator will be flashing.2. Enter the [LOCATION NUMBER] of the program location that you wish to view or change.3. Press the [*] star key. The READY indicator will continue flashing and the ARMED indicator willcome on.4. Enter the [SUB-LOCATION NUMBER] for the program location that you wish to view or change.5. Press the [*] star key, a long beep indicates a valid data entry. The READY indicator will continueflashing and the ARMED and AWAY indicators will come on.6. Enter the [NEW DATA] followed by the [*] star key. A long beep will indicate a valid entry. TheAWAY indicator will turn off.