215 REPEATER OPERATIONTo be accessed, some repeaters require subaudible tones onthe input signal. Subaudible tones are added to your normalsignal and must be set in advance.DD Setting the subaudible tone frequencyqWhile pushing and holding [FUNC], push and hold[SQL] (ATT•SET) for 1 sec. to enter set mode.wRotate [DIAL] to select “R TONE.”eWhile pushing and holding [FUNC], rotate [DIAL] to selectthe desired subaudible tone frequency.• See the tables at right.r Push [SQL] (ATT•SET) to exit set mode.• Available tone frequency listNOTE: The transceiver has 50 tone frequencies and con-sequently their spacing is narrow compared to units having38 tones. Therefore, systems using some tone frequenciesmay receive interference from signals using adjacent tonefrequencies.✔ CONVENIENT!Tone scan function: When you don’t know the subaudibletone used for a repeater, the tone scan is convenient for de-tecting the tone frequency. (p. 48)While pushing and holding [FUNC], pushing and holding[CALL] ( MODE • SCAN ) for 1 sec. to start the repeater tonescan.• Push [CALL] (MODE •SCAN ) to cancel the scan.• When the required tone frequency is detected, the scan pauses.67.069.371.974.477.079.782.585.488.591.594.897.4100.0103.5107.2110.9114.8118.8123.0127.3131.8136.5141.3146.2151.4156.7159.8162.2165.5167.9171.3173.8177.3179.9183.5186.2189.9192.8196.6199.5203.5206.5210.7218.1225.7229.1233.6241.8250.3254.1ATTDTCST SQLSQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519After1 sec.SCANS.MWSET[DIAL]SET■ Subaudible tonesPush Push and hold Dual operation