225REPEATER OPERATION5DD Setting the subaudible tone encoder ON/OFFqWhile pushing and holding [FUNC], push and hold[SQL] (ATT•SET) for 1 sec. to enter set mode.w Rotate [DIAL] to select “T/TSQL.”eWhile pushing and holding [FUNC], rotate [DIAL] to selectthe repeater tone from “TONE” or “OFF.”r Push [SQL] (ATT•SET) to exit set mode.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519Tone squelch with pocketbeep function selectionDTCS with pocket beepfunction selectionSubaudible tone OFFTone squelchselectionDTCS selectionRepeater tone selectionTonedecoderselectionsATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519After1 sec.Some European repeaters require a 1750 Hz tone burst to beaccessed. For such European repeaters, perform the follow-ing.q Set the receive frequency (repeater output frequency).wSet the shift direction of the transmit frequency. (–DUP or+DUP; see p. 19 for details.)• “–DUP” or “+DUP” indicates a minus or plus offset of the transmitfrequency, respectively.eWhile pushing and holding[PTT], push and hold[SQL] ( ATT • SET ) for 1 to 2sec. to transmit a 1750 Hztone burst signal.• The displayed frequency auto-matically changes to the trans-mit frequency (repeater inputfrequency).• If “OFF” appears, check the off-set frequency (see p. 20 for de-tails) or shift direction (p. 19).r Push and hold [PTT] to trans-mit.t Release [PTT] to receive.yPush and hold [SQL] ( ATT • SET ) to monitor the repeaterinput frequency.SCANS.MWSETSET■ 1750 Hz tone