Icom IC-P7A Instruction Manual

Also see for IC-P7A: Instruction manual

Contents

407SCAN OPERATION7tPush [CALL] (MODE•SCAN) several times; or while pushingand holding [CALL] ( MODE • SCAN ), rotate [DIAL] to select“S.MW.”yPush and hold [V/M] (SKIP •S.MW) for 1 sec. to set the skipcondition.• “SKIP” or “PSKIP” indicator appears, according to the skip se-lection in step r.✔ CONVENIENT!The skip setting can also be easily set with the following op-eration.qSelect the desired memory channel to be set as a skipchannel/frequency.wWhile pushing and holding [FUNC], push [V/M]( SKIP • S . MW ) momentarily to select the skip condition from“SKIP,” “PSKIP” and “OFF (no indication).”✔ CONVENIENT!During VFO scanning, such as programmed scan, the skipsetting can be programmed into the highest blank memorychannel which is automatically selected with the following op-eration.q Start the VFO scan.➥ Select VFO mode with [V/M] (SKIP •S.MW).• Select the desired frequency band with [BAND] ( TS•LOCK ), ifdesired.➥ Push and hold [CALL] (MODE •SCAN ) for 1 sec. to enterscan type selection condition.➥ Rotate [DIAL] to select the desired scanning type.• “ALL” for full scan; “BAND” for band scan, “PROGxx” for pro-grammed scan (xx= 0 to 24; programmed scan edges num-bers only displayed)➥ Push [CALL] (MODE •SCAN ) again to start the scan.• Scan pauses when a signal is received.• Rotate [DIAL] to change the scanning direction, or resumesmanually.wWhen scan pauses and you want to set the paused fre-quency as a skip frequency.➥ Push and hold [FUNC] then push [V/M] (SKIP •S.MW) for1 sec. to store the paused frequency into the highestblank memory channel.• While pushing and holding [FUNC], scan pauses; and afterwriting the frequency, scan resumes.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO PSKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO PSKIPMR519• Skip channel setting • Program skip setting“SKIP” appears“PSKIP” appears