Icom IC-R6 Instruction Manual

Also see for IC-R6: Price list Instruction manual Instruction manual Service manual

Icom IC-R6 Instruction Manual Manual pdf 43 page image

306SCAN OPERATIONNew200112345678910111213141516■ Scan edges programmingScan edges can be programmed in the same manner asmemory channels. Scan edges are programmed into scanedge memory channels, 00A/00B to 24A/24B.q Push [V/M] to select the VFO mode.w Set a desired frequency:➥ Push [BAND] to select a desired band.➥ Rotate [DIAL] to set a desired frequency.➥ Set other data (e.g. frequency offset, duplex direction, tonesquelch, etc.), if desired.e Hold down [S.MW](V/M) for 1 second to enter the selectmemory write mode.• 1 short and 1 long beep sounds.• The “ ” icon and memory channel number blink.r Rotate [DIAL] to select a desired programmed scan edgechannel from 00A to 24A.t Hold down [S.MW](V/M) for 1 second.• 3 beeps sound• The matched “B” channel is automatically selected if you con-tinue to hold down [S.MW](V/M) after programming.y To program a frequency for the other pair of scan edges,00B or 24B, repeat steps w and t.• If the same frequency is programmed into a pair of scan edges,the programmed scan will not function.RotateHold down for 1 sec. to select channel 03A.Hold down for 1 sec. to program.The VFO mode Enter the select memory write mode.Return to the VFO mode.[EXAMPLE]: Programming 145.370 MHz into scan edge channel 03A (a blank channel).