Icom IC-T2H Instruction Manual

Also see for IC-T2H: Service manual Instruction manual

114BASIC OPERATION Setting a frequencyD Via the keypad➀ Push [A V] to select VFO mode, ifnecessary.➁ Push 6 digit keys, starting fromthe 100 MHz digit, to input a fre-quency.• Push the [M] key first to start inputfrom the 100 kHz digit, if desired.• When a digit is mistakenly input,push [ ] and input from the begin-ning.• “2” and “7” are acceptable for the 1kHz digits (depending on the 10 kHz digit).D Using the [Y]/[Z] keysEach push increments/decrements the frequency accordingto the selected tuning step (see right), except when the 100kHz or 1 MHz dial select step is selected (see followingpage). When a dial select step is selected, each push incre-ments/decrements the frequency either 100 kHz or 1 MHz.ower ON[PWR/VOL] clockwisepower ON.ggling frequency/channelication modeel indication mode is used to simplify operation. In thisonly pre-programmed memory channel numbers areed and functions are limited ([PWR/VOL], [D L], [PTT],] and [SC] are functional).gle between the indication modes:pushing [Z] + [0], rotate [PWR/VOL] to turn power ON.ncy indication Channel indicationat power ON0AT POWER ONMRMR0 0554101.12.5 4:31 PM Page 11 (1,1)