Icom IC-T2H Instruction Manual

Also see for IC-T2H: Service manual Instruction manual

258SCAN OPERATIONrogrammed scanmmed scan repeatedly scans between two user-pro-ed frequencies (memory channels “PA” and “Pb”). Thisuseful for checking for signals within a specific fre-y range such as repeater output frequencies, etc.h [A V] to select VFO mode, if necessary.h [SC] to start the scan.change the scan direction, push [Y] or [Z].h [SC] again to stop the scan.TE: Scan edges, PA/Pb, must be programmed in ad-ce (program them in the same manner as regularmory channels—p. 19).e same frequencies are programmed into the scanes, programmed scan will not proceed. Memory (skip) scanMemory scan repeatedly scans all programmed memorychannels, except those set as skip channels.➀ Push [A V] to select memory mode, if necessary.• “X” appears.➁ Push [SC] to start the scan.• To change the scan direction, push [Y] or [Z].➂ Push [SC] again to stop the scan.D Setting skip channelsIn order to speed up the scan interval, you can set memorychannels you don’t wish to scan as skip channels.➀ Push [A V] to select memory mode, if necessary.• “X” appears.➁ Push [Y]/[Z] to select a memory channel to set as a skipchannel.➂ Push [SC] for 1 sec. to toggle theskip setting on/off.• “SKIP” appears when the channels isset as a skip channel.• If memory scan is accidentally started,push [SC] to stop it.MRSKIPMemory channel 10 isset as a skip channel.01.12.5 4:31 PM Page 25 (1,1)