Icom IC-T2H Instruction Manual

Also see for IC-T2H: Service manual Instruction manual

1 ANI OPERATIONOperationCalling a specific stationTurn power on and set the [VOL] control to the 10 or 12 o’-clock position.Push the [Y]/[Z] keys to set the desired channel.• “ ” appears when the ANI function has been programmed viacloning.Push [PTT] once to connect to the selected station or entera 3-digit ANI code, if required (in this case it is not neces-sary to push [PTT]—transmit is automatic after entry of the3rd digit).• The transceiver transmits the pre-programmed selective code.When the transceiver rings (an answer back is received),wait for a connection code from the connected station;when the transceiver doesn’t ring, push [PTT] again to exitthe standby condition, then try again from step ➂ after wait-ing awhile.When the connection code is received, a beep sounds,then “ ” flashes; when the connection code is not re-ceived within 10 sec., the transceiver transmits a discon-nect code automatically (“ ” does not flash). Try againfrom step ➂ after waiting awhile , in such a case.When “ ” flashes, you can converse with the connectedstation.• Push to transmit; release to receive.When your conversation is finished, transmit the discon-nect code.• While pushing [PTT], push [#].• Some transceivers cannot transmit a disconnect code depend-ing on programming.NOTE: When your conversation extends into the ANI time-out time, the transceiver transmits a disconnect code au-tomatically.Transmita selective codePush [PTT] toexit standbyConverseTransmit adisconnect codemanuallyReceive ananswer backcodeReceivea connectioncodeTransmitdisconnect codeautomaticallyNoYesNoTry again after a while01.12.5 4:31 PM Page 34 (1,1)