Icom IC-T2H Instruction Manual

Also see for IC-T2H: Service manual Instruction manual

OTHER FUNCTIONSInitial set modeial set mode is accessed at power on and allows you toseldom-changed settings. In this way you can “customize”nsceiver operations to suit your preferences and operatingle.Entering initial set modeWhile pushing [8] + [0], rotate [PWR] to turn power on.• The transceiver enters initial set mode and “mS SImP” or “mSnoRm” (see right) is displayed.Push [t] one or more times to select the desired displayas described on the following pages.Push [Y]/[Z] to select the desired condition.Turn power off, then on again to exit initial set mode andselect the previous operating mode.Messageen no operation is performed for 5 sec. in initial set mode,essage scrolls across the function display prompting youinput.Message examplemicrophone simple modeAT POWER ON D Mic simple mode (Optional HM-75A required)This item turns the microphone simplemode on or off. Microphone simplemode is used to change the functionassignments for switches on the op-tional HM-75A REMOTE CONTROL MI -CROPHONE as below. This assignmentis convenient for 3-channel use ofsimple operation.*Functions only when in conversation mode.NOTE:Turn power off when connecting the HM-75A to the trans-ceiver.VFO mode cannot be selected via the microphone whenSIMPLE mode is selected.NORMAL SIMPLEFreq. CH ANI Freq. CH ANIHM-75Aindication indication indication indication SWITCH[CALL] NULL NULL [ ] [ ] [ ]*[V/m] NULL NULL [CALL] NULL NULL[UP] [UP] [UP] MCH01 MCH01 MCH01[DOWN] [DOWN] [DOWN] MCH02 MCH02 MCH02AB001.12.5 4:31 PM Page 28 (1,1)