338 SCAN OPERATION Priority watchPriority watch checks for signals on “priority channels” while oper-ating on a VFO frequency.D Memory or call channel watchWhile operating on a VFO frequency, memory or call channel watchmonitors for signals in the selected memory or call channel every5 sec.q Select the desired memory channel or the call channel.w Push [D•CLR] to select VFO mode.e Push [7•PRIO] after pushing [A•FUNC] to start watching.• VFO is displayed, then the decimal point “.”, on the frequency read-out flashes.• The priority channel is monitored every 5 sec.• When the signal is detected on the priority channel, the watchingis paused according to the setting of the scan resume condition.r Push [D•CLR] to stop watching.D Memory scan watchWhile operating on a VFO frequency or the call channel, memoryscan watch monitors for signals in each memory channel in se-quence, every 5 sec.q Push [C•MR] to select memory mode, if necessary.• “X” appears.w Push [5•SCAN] after pushing [A•FUNC] to start the memory scan.e Push [7•PRIO] after pushing [A•FUNC] to start the watching.• VFO is displayed, then the decimal point “.”, on the frequency read-out flashes.• When the signal is detected on the priority channel, the watchingis paused according to the setting of the scan resume condition.r Push [D•CLR] to stop the watching.