13• Have the exhaust system and the fireplace inspected by a qualified technician every year before the heatingseason begins. • Use a gentle cleaner on the windows. Do not use abrasive products; abrasive products damage glass willdamage the surface of the glass.J. A. ROBY assumes no liability and makes no warranties if some of this eventuality became.• A bad installation.• Used with a damaged component.• A vent system installation that does not met J. A. ROBY’s instructions;• The crushed glass was not placed properly on the burner• Used of any component not approved by J. A. ROBY.1.3 GENERAL SAFETY INFORMATION1.3.1 CARBON MONOXIDE• An installation that does not comply with the recommendations described in this manual can lead to carbonmonoxide emissions. As a safety measure, we strongly recommend for a carbon monoxide detector to beinstalled near the unit.Signs of a carbon monoxide poisoning (headaches, dizziness and nausea) are similar to those ofinfluenza. If you have these symptoms, your fireplace may not have been installed correctly. Turn offthe gas fireplace and go outside immediately for some fresh air! Have the fireplace inspected by aqualified technician.1.3.2 GAS ODOR• Propane gas/LPG and natural gas are odorless. An odorant (usually sulfur) is added to each one of these gaseswhich makes them smell similar to rotten eggs. This will help you easily detect any eventual leak. However, theodor added to these gases can fade. Gas may be leaking without releasing any smell. We therefore stronglyrecommend that a gas detector be installed near the unit.THE INSTALLER MUST READ THIS MANUAL CAREFULLY BEFORE INSTALLING ORUSING THIS APPLIANCE. PLEASE REFER TO LOCAL CODES, WHERE APPLICABLE.WARNING:It is important to handle all appliance components (doors, SmartCase®, burner, etc.) with care during maintenance.