J. A. Roby SUROIT / RGV-25 Installation And Operation Manual

Also see for auster RGCG-25: Installation and operation guide

Contents

J. A. Roby SUROIT / RGV-25 Installation And Operation Manual Manual pdf 53 page image

53• The fireplace must be disconnected from the gas supply system when components that measure intake gaspressure are being installed. Once the gas supply is reconnected, check all connections as well as the gasmeter (or tank) connected to the fireplace for tightness. Make sure there are no leaks (sees section 6.6).6.5 PROCEDURE FOR CHECKING GAS PRESSURE FROM THEFIREPLACE VALVE• Make sure the manual valve is closed.• Loosen the input “IN” and/or the output“OUT” pressure verification port(s) byturning counter clockwise with a 1/8 in.(3 mm) wide screwdriver (figure 6.5).• Connect the pressure gauge to theinput “IN” and/or output “OUT” pressureverification port(s) using a rubber hosewith a 5/16 in. (8 mm) inner diameter.• Open the manual valve (you will getthe intake pressure).• Turn on the fireplace to check outlet pressure.• When you are done reading the pressure gauge, turn off the fireplace, close the manual valve, disconnectthe hose and tighten the screw(s) (clockwise) with a small flat screwdriver (1/8 in. wide).Make sure the output pressure of the automatic valve is comprised between the numbers listed in this table.6.6 CHECKING GAS LINES FOR TIGHTNESS• Fill a spray bottle (figure 6.6) with soapy water (5% soap, 95% water).• Spray liberally over all screwed gas line connections (from the tank to the fireplace).• If no bubbles appear it means the assembly is tight.• If there are bubbles, it means there is a gas leak. If this occurs, immediately refer tosection 1.2.1 and follow instructions.WARNING:Never use an open flame to check for gas leaks.Output pressure of the automatic valveFigure 6.5Figure 6.6