413.5 DECORATIVE PANEL INSTALLATIONTo make brick pattern plate installation easier a notch is made at the bottom of the plate to pass over the burnerwithout to remove it. But the surrounding burner plate or logs have to be removed. Otherwise you cannot installthe brick pattern plates.Depending on the model, both plate sizes could be required. Always start by installing the small plate.3.5.1 SMALL PLATE INSTALLATION• Insert the plate from the top. To do so, tilt the plate and insert it between the beams, then push it up (figure3.5.1.a).• Push the plate all the way to the back so that it stands vertically and press it against the base (figure 3.5.1.b).• Fold the retaining tabs located at the top of the fireplace (figure 3.5.1.c).3.5.2 LARGE PLATE INSTALLATION• Insert the plate from the top. To do so, tilt the plate and insert it between the little plates then push up (figure3.5.2.a).• Push the plate all the way to the back so that it stands vertically and press it against the base (figure 3.5.2.b).• Fold the retaining tabs located at the top of the fireplace (figure 3.1.2.c).Figure 3.5.2.cFigure 3.5.2.bFigure 3.5.2.aFigure 3.5.1.bFigure 3.5.1.a Figure 3.5.1.c
