20To clean oven cavity surfaces:To avoid damage to oven cavity surfaces, do not use soap-filledscouring pads or abrasive cleaners. The oven cavity should becleaned at regular intervals, especially if spillovers have occurred.Cleaning Method:■ Steam Cleaning Function: See “Steam Cleaning” in the“Maintenance Functions” section.■ To clean the oven cavity surfaces (including the oven cavityceiling), remove the wire shelf and shelf supports and wipethe interior of the oven and the shelf supports clean. See the“Shelf Supports” section.ACCESSORIESCleaning Method:■ The following accessories are dishwasher safe: wire shelf,baking/drip tray, steam tray and shelf supports.■ Remove the water pipe from the water container for easycleaning. Soak the water pipe in water with liquid detergent.The water pipe is not dishwasher safe.■ Use a sponge with a mild detergent to clean the watercontainer. The water container is not dishwasher safe.NOTE: Remove, empty and dry the water container aftereach use.■ Soak the seals and rings from the light bulb assembly inwater with liquid detergent. The seals and rings are notdishwasher safe.■ Wipe the temperature probe clean with a clean, damp clothor paper towel with mild detergent and water after use. Donot immerse the temperature probe in water when cleaning.To avoid scratching the surface, do not use steel-wool pads.Shelf SupportsThe shelf supports can be removed to better clean the ovencavity walls.To Remove Shelf Supports1. Pull the shelf support toward the front of the oven.2. Unhook the shelf supports from the oven cavity wall hooks.3. Repeat steps 1 - 2 with the other shelf support.To Replace Shelf Supports1. Slide the shelf support onto the oven cavity wall hooks andpush toward the back of the oven.2. Repeat Step 1 with the other shelf support.Oven LightThe oven light is a 12-volt, 10-watt maximum, type G4 heat-resistant halogen bulb.To Replace the Oven Light:Before replacing the bulb, make sure the oven is off and cool.1. Disconnect power.2. Turn the glass cap counterclockwise to unscrew.3. Remove the seals and metal ring and clean the glass cap.4. Replace bulb using a tissue or wearing cotton gloves tohandle bulb. To avoid damage or decreasing the life of thenew bulb, do not touch bulb with bare fingers.5. Replace the bulb into bulb holder, metal ring and seals to theglass cap.6. Replace the oven light assembly to the oven cavity by turningit clockwise.7. Reconnect power.A. Shelf supportB. Oven cavity wall hookBAA. Oven cavity wall hookB. Shelf supportA. Glass capA. Glass capB. SealsC. Metal ringD. Halogen bulbABAABCD