Jenn-Air JBS7524BS Use And Care Manual

Also see for JBS7524BS: Design and planning guide Use & care guide Instructions

Jenn-Air JBS7524BS Use And Care Manual Manual pdf 5 page image

5BEFORE USING THE OVENIMPORTANT: Complete the following steps before oven is usedfor the first time.1. Open the oven door, remove the accessories and make surethat the oven is empty.2. Rinse the water container with tap water (no detergents) andthen fill it to the “MAX” mark with fresh tap water. Slide thewater container into its compartment until it is firmly seated inplace.3. Run the Calibration function. See “Calibrate” in the“Maintenance Functions” section.ELECTRONIC OVEN CONTROLControl PanelThe control panel houses the control menu and function controls.The control keypads are very sensitive and require only a lighttouch to activate.For more information about the individual controls, see theirrespective sections in this manual.The functions described in this section will work only if the ovenis On. To turn the oven On, press ON/HOME.Electronic Oven DisplayWhen power is first supplied to the oven, the display will promptyou to set the Language and 24-hour clock. After a power failure,the clock will flash and will need to be reset. See “Language” and“Time” in this section.This oven has a number of functions that can be adjusted to yourpersonal taste. See the appropriate section in this manual for thesetting you want to adjust.On/Off/PauseThe oven can be turned On or Off or paused using the ON/HOMEbutton. A function can also be paused by opening the oven door.When the oven is On, all buttons function normally, and the24-hour clock is not displayed. When the oven is Off, only the OKbutton will work. The 24-hour clock will be displayed.SettingsYou can control several settings through the Settings Menu:Temperature Units, Language, Time, Display Brightness, SignalVolume and Eco Mode.To access the Settings Menu, press the up or down buttons until“Settings” is selected on the display, then press OK to confirm.LanguageThe language must be set on the display after power is suppliedto the oven.To Set the Language:1. Press ON/HOME.2. Press the up or down buttons until “Settings” is selected onthe display, then press OK to confirm.3. Press the up or down buttons until “Language” is selected onthe display, then press OK to confirm.4. Press the up or down buttons until the desired language isselected on the display, then press OK to confirm.5. Press BACK to exit the settings function when you are done.A. CancelB. On/HomeC. Digital displayD. Up/down - to scroll up/down or adjust tohigher/lower valuesE. Start (control lock hold 3 sec)F. Ok - to confirm settingG. Back - to return to the previous screenH. Most used - 10 most used functionsBCADEGHF