Jenn-Air JES8750BAB Use & Care Manual

16Convect Bake (select models)To set Convect Bake:1. Press the Convect pad.2. Select CNVT BAKE using the Quickset pads.Convect OptionsCook & Hold and Delay options are available when convectcooking. See page 15 for information on how to program aCook & Hold or Delay option.CONVECT CONVECT CONVECTBAKE ROAST PASTRYMultiple-Rack Whole Chicken Frozen PieBaking of Whole Turkey TurnoversCookies/Biscuits Vegetables Cream PuffsBreads Pork Roasts Puff PastryCasseroles Beef RoastsTarts/TortesCakes3. Select the oven temperature using the Quickset padsOREnter the desired temperature using the number pads.Press Enter pad to set.Notes:• For best results, use rack position 2 or 3 when using theRapid Preheat option.• For optimum baking and browning results, Rapid Preheatis not recommended when baking on multiple racks.Convect Roast (select models)To set Convect Roast:1. Place food in the oven.2. Press the Convect pad.3. Select CNVT ROAST using theQuickset pads.Convect (select models)Convection uses a fan to circulate hot air evenly over, underand around the food. As a result, foods are evenly cookedand browned, often in shorter times, at lower temperaturesand with the flexibility of using more than one rack at a time.Notes:• The oven control comes from the factory set for AutoConvect Conversion. When using Convect Bake andConvect Pastry enter the conventional bakingtemperature. The control automatically converts thetemperature to 25° less than the conventionaltemperature.• When using Convect Roast the temperature will not beautomatically reduced. Enter the conventional roastingtemperature and time. The control then lets you knowwhen 75% of the time has elapsed and alerts you tocheck the food for doneness.• To turn Auto Convect Conversion off, see page 27.Cont.• The temperature can be set from 195° F to 550° Fdegrees in 5° increments. If Auto Convect is off,temperature can be set from 170°.• After three seconds, the oven will begin to preheat.CNVT BAKE and PREHEAT will appear in the displayalong with 100° or the actual oven temperature,whichever is higher.• The temperature in the display will increase in 1°increments until the oven reaches the presettemperature. Allow about 15 minutes for the ovento preheat.• When the oven is preheated, the oven will beep,PREHEAT will turn off and CNVT BAKE will be displayed.AUTO will be displayed if Auto Convect Conversionfeature is turned on.• Place food in the oven.4. At the end of cooking, turn the oven off bypressing the CANCEL pad. Remove foodfrom the oven. The oven will continue operating until theCANCEL pad is pressed.Rapid Preheat (select models)Use to decrease preheating time when using Bake or ConvectBake. Use for all foods when baking on one rack.• After Bake or Convect Bake has been programmed andactivated, press the Rapid Preheat pad.• 1 RACK ONLY will display, after 10 seconds the display willshow RAPID and PREHEAT.To return to Standard Preheat:• Press Rapid Preheat pad again. This will provide standardpreheat and PREHEAT and the selected function will bedisplayed.