Jenn-Air JES8750BAB Use & Care Manual

29Tones (beeps)The number of beeps heard at the end of cooking and at theend of timer operation and their volume can be adjusted.To adjust the beeps:1. Press Setup pad.2. Use the arrow to scroll.3. Select TONES.To change the beeps at the end of cooking:1. Follow “Tones” steps 1-3 (see above).2. Select COOK TONE.3. Use the arrow to scroll.4. Select 1-30 MIN to hear one beep every thirty seconds.ORSelect 1-60 MIN to hear one beep every sixty seconds.ORSelect 1 BEEP to hear one beep only at the end ofcooking.5. Press the Setup pad to exit.To change the timer beeps:1. Follow “Tones” steps 1-3 (see above).2. Select TIMERS TONES.3. Use the arrow to scroll.4. Select 2-30 SEC to hear two beeps every thirty seconds.ORSelect 2-60 SEC to hear two beeps every sixty seconds.ORSelect 1 BEEP to hear one beep only at the end of theset time.5. Press the Setup pad to exit.To change the volume of the beeps:1. Follow “Tones” steps 1-3 (see above).2. Press the arrow to scroll.3. Select VOLUME.4. Select HIGH for the highest volume.ORSelect MEDIUM for medium volume.ORSelect LOW for the lowest volume.5. Press the Setup pad to exit.12 HR ShutoffThe oven will automatically turn off at the end of 12 hours ifyou accidentally leave it on.To turn off this feature:1. Press Setup pad.2. Use the arrow to scroll.3. Select 12HR SHUTOFF.4. Select ON or OFF using the Quickset pads.5. Press the Setup pad to exit.Energy SaverTo save energy, the display can be set to go dark if it is notbeing used.To set the Energy Saver feature:1. Press Setup pad.2. Use the arrow to scroll.3. Select ENERGY SAVER.4. Select ON or OFF using the Quickset pads.5. Press the Setup pad to exit.Press any pad to “wake up” the display.ServiceThis area of the oven control displays the Jenn-Air CustomerService toll-free phone number.1. Press Setup pad.2. Use the arrow to scroll.3. Select SERVICE.4. Press the Setup pad to exit.DemoWhen Demo is selected, you will see a short presentationhighlighting the features of your new Jenn-Air range.1. Press Setup pad.2. Use the arrow to scroll.3. Select DEMO.4. Select ON or OFF using the Quickset pads.5. Press the Setup pad to exit.