ABT-BA-e-1312 4713.1.2 Anti-convection modeIf measurements have to be taken under unavoidable ambience conditions, (e. g.changing air condition systems) convection occurring within the weighing space mayresult in fluctuations in the display on the balance after the stability display has ap-peared. The small range (readability 0.01 mg) of series ABT is particularly suscepti-ble to this effect.Anti-convection mode adjusts the timing of appearance of the stability mark. Notethat the stability mark will then appear at a late timing.Repeatedly press the [CAL] key until "ConvECt" appears.To set anti-convection mode, press the [TARE] key.Setting of this mode can be confirmed only in settings checkdisplay (see ch. 12.6).13.1.3 High-stability ModeThe balances of series ABT are designed to react only minimally to the effects ofvibrations and drafts. However, if it must be set up in a location with poor conditions,use this function to reduce the effects of vibration or air current even further. There isa slight increase in the reaction time of the balance but the display itself is stabilized.Repeatedly press the [CAL] key until "ConvECt" appears.To set high stability mode, press the [TARE] key.Setting of this mode can be confirmed only in settings checkdisplay (see ch. 12.6).Setting controldisplay(when selectinganti-convection mode)Setting controldisplay(when selectinghigh-stability mode)