ABT-BA-e-13125414 Application Functions14.1 Parts countingWith parts counting you can either count parts into a container or remove parts froma container. To count a greater number of parts the average weight per part has tobe determined with a small quantity (reference quantity). The larger the referencequantity, the higher the counting exactness. High reference must be selected forsmall parts or parts with considerably different sizes.The process has four steps:• Tare the weighing container• Determine the reference unit• Weigh in the reference unit• Count the itemsCondition: Function "U- PSC" activated (ch. 11.3)(When PCS is used for thefirst time)Repeatedly press the [UNIT] until display is in percentagemode. The display symbol PCS pops up.If you are using a weighing container use the [TARE] key fortaring.To determine the reference piece number, place 10, 20, 50 or100 counting parts on the balance.Press the [CAL] keyRepeated pressing of the [CAL] key allows the change betweenthe following reference piece numbers "Ld 10", “Ld 20”,“Ld 50”and “Ld 100”.Important: The larger the reference quantity, the more accuratethe parts counting.(When loading 20 pieces)When standstill control ( ) is complete, confirm your referencepiece number by pressing the [TARE] key.The display shows "SEt" for several seconds and the storedreference piece number is displayed.