Kemppi FastMig X 450 Operating Manual

Also see for FastMig X 450: Quick guide Quick guide Service manual

ENInfo Shows following information about the selected device.Device name:DevSW: Unit software version.SysSW: System software version (base software version).BootSW: Boot software version.SW Item: Software item number (IFS code).Serial: Device serial number.Prog: Programmer nameDate: Programming time and date.Restore Settings User 1 (one of ten users) Channel:Selected user can restore to his backup memory channels one by one.Other users’ memory channels remain untouched.Setup settings remain untouched.User 1 (one of ten users) All Channels:Selected user can restore all of his backup memory channels (0-9) at one time.Other users’ memory channels remain untouched.Setup settings remain untouched.Restore To Factory:All channels (of all users) are removed.All users’ backup channels are removed.All setup settings are set to defaults.When MMA/CC/CV Mode is selected, the Restore Settings options are:MMA/CC/CV ChannelMMA All channelsRestore To FactoryLicence Menu Licence Code allows you to enter the licence code:- Up and down arrows are used to select the code number position.- Pulse encoder is used to select the code number (0–255) to be entered.- Soft key button on the right is used to activate the licence number (after all numbers havebeen entered). In case the code was wrong the earlier view will be displayed.Licence Timers allows you to check the remaining time of the time-based Wise features.WeldData Delay 1…60 s Step: 1Factory Setting is 20 s.Defines how long time the Weld Data isdisplayed after welding ends.Weld Data display is also turned offwhen pulse encoder is turned or anybutton is pressed.Display Delay 1…20 s Step: 1Factory setting is 10Defines how long time the informationis displayed (e.g. “Setting Saved” text).This is not always the exact time.Pre Gas Time 0.0…9.9 s, CURVE. Step: 0.1Factory settings is CURVECURVE: Pre Gas time is read from theWelding program.0.0 – 9.9s: User Pre Gas time setting.Post Gas Time 0.0…9.9 s, CURVE. Step: 0.1Factory settings is CURVECURVE: Pre Gas time is read from theWelding program.0.0 – 9.9s: User Post Gas time setting.FastMig X 45018