ENADMINISTRATOR MENUChange PIN Code Factory PIN code is 0000 Administrator pin code change.Ask PIN OFF, StartUp, Menu Factory setting is OFF PIN code inquiry selectionOFF: No PIN code inquiry.StartUp: Control panel X 37 always asksfor the PIN code when the machine isturned on. Wire feeder panel XF 37 isnot affected and always works withoutPIN.Menu: Control panel X 37 asks forthe PIN code every time when MENUbutton is pressed and when the displayis in channel info mode (in start-upview). PIN code inquiry is made onlyonce when entering the menu. Afterthat the menu button can be pressedany time without PIN inquiry.BUTTON FUNCTIONSON / OFF button • Short press returns the panel to default initial view (channel information).• Long press (>5 sec) turns X 37 panel and wire feeder panel XF 37 ON or OFF.• Keeping this button pressed while turning the machine ON restores to factory settings. Thepanel asks for a confirmation before restoring to defaults.• If X 37 panel is OFF and a wire feeder panel XF 37 is turned ON, the X 37 panel will also be turnedON and linked automatically to this wire feeder panel.F1 button • Gives further information of selected memory channel.• Keeping F1 pressed while turning the machine ON restores the menu language to English.F2 button • Browses and selects users: 1…10, Administrator.• When MMA/CC/CV is selected, only Administrator is allowed.F3 button (WF#) • Selects another wire feeder as a setup target. Panel allows selecting only those WF numbers thatare found connected on the system.• When MMA/CC/CV is selected, the display shows text ”MMA/CC/CV Mode”.Channel +/- Browses and selects memory channels.Up/down arrow Moves the selection up and down in the menu.Right and left softkey buttonsFunction depends on which menu command is active. The function is shown on the display.4.5 Welding software delivery profileConnected to Kemppi's MXF or MXP wire feed units, FastMig X 450 power source makes a veryefficient, multi-process welding system.After delivery and installation, your system will include welding software specified at the pointof order.If your welding needs change and you wish to update your FastMig X 450 system in the future,you can order additional welding programs or Wise™ and Match™ welding software and loadthem to your system with Kemppi DataGun field programming device.See further information about the available welding programs, modified processes, Match™functions and special enhanced arc performance solutions in the wire feeder's operatingmanual or on Kemppi's web site at www.kemppi.com.More welding programs are available by purchasing MatchCurve and MatchCustom products.FastMig X 45020