Kenwood DPX593BT Instruction Manual

ENGLISH 33You can control the unit with the steering remote control keys on yourvehicle. After connection, you can configure the control keys according toyour preference.• You can only make this configuration if your vehicle is equipped withthe electrical steering remote control.• If the steering remote control in your car is not compatible,configuration may not be completed and an error message may appear.( 41)Make the connectionConfigure the control keys1 Press repeatedly to enter STANDBY.2 Press the volume knob to enter [FUNCTION].3 Turn the volume knob to select [SYSTEM], then press the knob.4 Turn the volume knob to select [USER S.REMO], then press the knob.5 Turn the volume knob to select [SET KEY], then press the knob.A key list of 16 assignable keys appears.• K## NONE: No function has been assigned.6 Turn the volume knob to select any key from the key list to assignthe function, then press the knob.“PRESS KEY TO ASSIGN K##” appears.LEARNING STEERING REMOTE CONTROL (for )Rear panelLearning steeringremote input terminalGray/redBright green/redPurple/redSteering remotecable (supplied)Connect to yourvehicle’s steeringremote harness.Contact yourKENWOOD dealerfor details.7 Press and hold any control keys on your steering remote controlwhich you want to assign.A list of key functions will appear on the display.NONE (default)/ATT/SEEK UP/SEEK DOWN/VOL UP/VOL DOWN/MODE/ON HOOK/OFF HOOK/VOICE/ENTER8 Turn the volume knob to select a function to assign, then press theknob.The selected key function is assigned to the steering remote controlkey you have selected in step 7.The display returns to the key list as on step 5.• K## (Function): When certain function has been assigned to a key.9 Repeat steps 6, 7 and 8 to assign other control keys.10 Press and hold to exit.To reassign the control keys1 Press repeatedly to enter STANDBY.2 Press the volume knob to enter [FUNCTION].3 Turn the volume knob to select [SYSTEM], then press the knob.4 Turn the volume knob to select [USER S.REMO], then press the knob.5 Turn the volume knob to select [RESET KEY], then press the knob.6 Turn the volume knob to select [YES], then press the knob.All the control keys will be reset.Selecting [NO] will cancel the operation.When [FACTORY RESET] is set to [YES] ( 6), it will also reset the learningsteering remote control.To return to the previous setting item, press .