Kenwood KDC-BT92SD Instruction Manual

Also see for KDC-BT92SD: Manual Service manual

51 | KDC-BT92SD English | 52Resetting of DTA SettingsYou can reset the DTA-compensated values to thefactory settings.1 Select the sourcePressing the [SRC] button repeatedly switchessource.Select a source other than “STANDBY”.✍ SRC Select mode 2: Press the [SRC] button andthen turn the [VOL] knob. To determine theselected source, press the [VOL] knob.2 Enter Audio Control modePress the [VOL] knob.3 Enter Reset DTA Setting modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “Pro Setup” > “DTA Settings” > “ResetDTA Setting”.4 Reset the DTA settingsTurn the [VOL] knob to select “YES”, and thenpress the [VOL] knob.Audio Preset MemoryRegistering the value setup by Sound Control.1 Setup Sound ControlRefer to the following operations to setup theSound Control.- Manual Equalizer Control (page 45)- Car Type Selection (page 47)- Speaker Setting (page 47)- X’Over Setting (page 48)- Listening Position Selection (page 49)- Listening Position Fine Adjustments (page 49)- Channel Level Fine Adjustments (page 50)2 Enter Audio preset memory modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “Pro Setup” > “Preset” > “Memory”.3 Select the number to put in the memoryTurn the [VOL] knob and press it when thedesired item is displayed.Select a preset number.4 Turn the [VOL] knob and press it when thedesired item is displayed.Select “YES”.“Memory Completed” is displayed.5 Exit Audio Control modePress the [MENU] button for at least 1 second.⁄• Register 2 patterns of Audio Preset Memory.• Preset number “1”:When you press the Reset, all the sources will be thesetting value which is registered.• Preset number “1” and “2”:The memory cannot be erased by the Reset button.• This function cannot be registered when the iPodEqualizer set in (page 44).Audio Preset RecallRecalling the sound setup registered by Preset Memory> (page 51).1 Select the sourcePressing the [SRC] button repeatedly switchessource.Select a source other than “STANDBY”.✍ SRC Select mode 2: Press the [SRC] button andthen turn the [VOL] knob. To determine theselected source, press the [VOL] knob.2 Enter Audio preset recall modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “Pro Setup” > “Preset” > “Recall”.3 Select the number to recall in the memoryTurn the [VOL] knob and press it when thedesired item is displayed.Select preset number.4 Turn the [VOL] knob and press it when thedesired item is displayed.Select “YES”.“Recall Completed” is displayed.5 Exit Audio Control modePress the [MENU] button for at least 1 second.⁄• The “User” of (page 44) ischanged to the value which was recalled.• The Equalizer curve is changed to the value which wasrecalled by the selected source.DSP Setup