| 
Installation the Microphone Unit1 Check the installation position of the microphone(accessory 3).2 Remove oil and other dirt from the installationsurface.3 Install the microphone.4 Wire the cable up to the unit with it secured atseveral positions using tape or the like.Fix a cable with a commercialitem of tape.Peel the release coated paper of double-face adhesive tape tofix on the place shown above.Adjust the direction of the microphone to the driver.Accessory 375 | KDC-BT92SD English | 76Installation/Removing the Unit Troubleshooting GuideSome functions of this unit may be disabled bysome settings made on this unit.! • Cannot set up the subwoofer.• No output from the subwoofer.• Cannot set up the subwoofer position of Manualposition setting.▲ • The Dual zone function is enabled. System> (page 45)• In the speaker select option, None is selected forthe subwoofer. (page 47)! Cannot set up the rear speaker.▲ In the speaker select option, None is selected for therear speakers. (page 47)! Cannot set up the tweeter.▲ In the speaker select option, None is selected for therear speakers. (page 47)! • Cannot set up the equalizer.• Cannot set up the Bass Boost.• Cannot set up the Sound Enhancements.• Cannot set up the Position control.▲ • The Dual zone function is enabled. System> (page 45)• The DSP function is disabled. “DSP Set” of Control> (page 43)• In the speaker select option, None is selected forthe rear speakers. (page 47)! • Cannot select the output destination of thesubsource in the Dual zone.• Cannot adjust the volume of the rear speakers.▲ The Dual zone function is disabled. System> (page 45)! Cannot set up Display.▲ (page 42) is notturned off.! The number of songs contained in “Songs”category of this unit is different from thatcontained in “Songs” category of iPod.▲ Podcast files are not counted in this unit as this unitdoes not support the playback of podcast files.What might seem to be a malfunction in your unitmay just be the result of slight misoperation ormiswiring. Before calling service, first check thefollowing table for possible problems.General? The operation check sound (beep sound) does notsound. The preout jack is being used. The Touch Sensor Tone cannot be output fromthe preout jack.? The illumination flashes when the knob or buttonis operated. This is the key illumination effect. You set this effect in “ILLUMI Effect” of Setting> (page 33).? The key illumination effect brought about inconjunction with the sound volume is small. The key illumination effect may be insufficientdepending on the sound volume and sound quality.Tuner source? Radio reception is poor. The car antenna is not extended. Pull the antenna out all the way.Disc source? The specified disc does not play, but another oneplays instead. The specified CD is quite dirty. Clean the CD, referring to the CD cleaning of thesection on CDs> (page 6). The disc is loaded in a different slot from thatspecified. Eject the disc magazine and check the numberfor the specified disc. The disc is severely scratched. Try another disc instead.Audio file source? The sound skips when an Audio file is beingplayed. The media is scratched or dirty. Clean the media, referring to the CD cleaning ofthe section on CDs> (page 6). The recording condition is bad. Record the media again or use another media. |
