|
24 | KDC-X494/ KDC-MP445U/ KMR-440UHD Radio™ tuner controlFunction of KTC-HR300/ KTC-HR200 (Optional Accessory)TuningSelecting the station.1 Select HD Radio sourcePress the [SRC] button.Select the “HD RADIO” display.For how to select source item, refer to source selection> (page 4).2 Select the HD FM bandPush the Control knob towards up.Switches between the FM1, FM2, and FM3 bandseach time you push towards up.Select the HD AM bandPush the Control knob towards down.3 Tune up or down programPush the Control knob towards right or left.If the sub channel is available in Digital FMbroadcast when 37 Seek Mode of setting> (page 16) is set to Auto seek or Manual, thechannel can be switched.Example:(HD FM band)Analog FM 1Digital FM 2Analog FM ™Digital FM-1ch 3Analog FM £Digital FM-2ch 4Digital FM-8ch 0Digital FM !… : Auto seek or Manual : Auto mode[4][¢]• During the reception of 1, tune up:2➡3➡4…• During the reception of !, tune down: !➡0…⁄• By using the 39 Receive mode of (page 16) the modes can be switched to digital broadcastautomatic switching, analog broadcast only, or digitalbroadcast only.• When “Digital” has been set with “Receive Mode”, theseek time will be longer to allow a check of whether thetransmission is a digital broadcast.• It will take few seconds to receive the digital broadcastingafter selecting the frequency.• When Tuning up, it will switch to the next frequency if it isswitched before receiving a Digital broadcast. (™➡£)• When Tuning down, it will received an Analog broadcastingif a Digital broadcast is not received. (!➡£)Station Preset MemoryPutting a station in the memory.1 Select the frequency to put in the memoryPush the Control knob towards right or left.2 Enter Preset Memory modePress the [ ] button.“LIST & MEMORY” is displayed.3 Select the number to put in the memoryTurn the Control knob.4 Determine the number to put in the memoryPress the [ENTER] button for at least 2 seconds.Cancelling the Preset Memory modePress the [ ] button.Preset TuningRecalling the stations in the memory.1 Enter Preset Tuning modePress the [ ] button.2 Select a desired station in the memoryTurn the Control knob.3 Recall the stationPress the [ENTER] button.Cancelling Preset TuningPress the [ ] button.
|
