|
26 | KDC-X494/ KDC-MP445U/ KMR-440USatellite Radio tuner (Optional Accessory) controlBasic OperationSelecting Satellite Radio sourcePress the [SRC] button.Select the “SIRIUS” or “XM” display.For how to select source item, refer to source selection> (page 4).⁄• You need to register to the service provider to receive theservice by Satellite Radio. Consult the service provider if“CALL … TO SUBSCRIBE” appears.• The radio may take a little time to start receiving after youselect the Satellite Radio source.• If the signal reception fails, “Acquiring Signal”/ “No Signal”appears.Selecting the channelPush the Control knob towards right or left.Selecting the Preset BandPush the Control knob toward up.Each time you push the knob, the preset bandalternates between the SR1, SR2, SR3 and SR4.Channel ScanEvery receivable Channel is checked for 10 seconds.1 Start Channel ScanPress the [S.MODE] button.2 Release it when the channel you want to listento is receivedPress the [S.MODE] button.Category and Channel SearchSelecting the channel and category you want toreceive.1 Enter Category and Channel Search modePress the [ ] button twice.2 Select the CategoryTurn the Control knob to select Category, andthen press the [ENTER] button.3 Select the ChannelTurn the Control knob to select Channel, andthen press the [ENTER] button.Cancelling Category and Channel Search modePress the [ ] button for at least 1 second.⁄• You cannot Channel search until the category informationis acquired.Channel Preset MemoryPutting the channel in the memory.1 Select the channel to put in the memoryPush the Control knob towards right or left.2 Enter Preset Memory modePress the [ ] button.3 Select the number to put in the memoryTurn the Control knob.4 Register channel to preset numberPress the [ENTER] button for at least 2 seconds.Cancelling the Preset Memory modePress the [ ] button.⁄• Only the channel number is stored. Category informationis not stored.Preset TuningRecalling the channels in the memory.1 Enter Preset Tuning modePress the [ ] button.2 Select a desired channel in the memoryTurn the Control knob.3 Recall the channelPress the [ENTER] button.Cancelling Preset TuningPress the [ ] button.
|
