VR-20£O/VR2080/KRF-VBBB1DiKRFW7771D[£niK]Connectionof videocomponentsIIIIIII II II1'1 II IIII ' IIM IIIII I IIII I I III IIII IIIThe connected components shown here are given as ex-amples because the available models vary depending onmarketing areas,Make connections as shown below,When connecting the related system components, referalso to the instruction manuals of the related compo-nents,Do not plug in the power lead until all connections arecompleted,*5VCR2 or video camera! AudioOUTMonitor TV5e S VIDEO(Front} jack is notprovided for theVR-2080,KRF-V7771D(U,S, Military)modelI Atso connect the system control cords when the KENWOODAudio Component System is connected.fudioRJTRF "1]DEMO-DULATORI!*2 *3FVideoOUTLD player AC-3 RF DemodulatorL ....... -___. (Kenwood LD player}8".... _ o_0'_1 I _ .... ' )} System con[rol cord/ _F I COAX_At II ToSYSTEMCONTROLIf --*2 Connection to the OPTICAL jackRemove the protective cap from theDIGITAL OUTPUT (OPTICAL) jack onlywhen it is used for connection,*3 The DIGITAL OUTPUT OPTICAL jack isprovided only for the VR-2090 andKRF-V8881D.About the S VIDEO jacks*4 Except for VR-2080 and KRF-V7771Dfor U.S, MilitaryS VIDEO cordUse the S VIDEO jacks to make connections tovideo components with S VIDEO IN/OUT jacks,Audio OU1Audio,IN ' J JI Video OUFi Video iNrVCRTelf you use the S VIDEO iacks to connect yourvideo playback components, be sure to use theS VIDEO jacks when connecting your men totand video recording components.eTo view the monitor "D,/in "Room B'°, connectthe composite video signal (yellow jacks) fromthe video source component to the receiver.eThe S VIDEO lacks of this unit are compatibleDigital OUT--[_UT,, 1 ]]Audio OUT / I ]l° .... J/ .... _ == ccc::j_-.,DVD player• TO connect a Video CD compatible CD player and outputs its video, connect the player to one of the sets of input jacks VIDE01 to VIDE04.In this case, do not connect the system controi cord to the CD player,DTS disclaimer clauseWhen Playing DTS-encoded CDs, excessive noise will be exhibited from the analog stereo outputs. The consumer should take properprecautions when the analog stereo outputs of the CD playe_ is connected to an amplification system, To enjoy DTS Digital Surroundplayback, an external 5,1 channel DTS Digital Surround decoder system must be connected to the digital output (S/PDIF, ASE/EBU, orTosLink} of the CD, LD or DVD player,