(No.RA018)1-754.19 Transmitter SectionItem Condition Measurement Adjustment Specifica-tions/RemarksPanel tuningmodePC test mode Test-equip-mentUnit Ter-minalUnit Parts Method1.Ramp upOffset1) Adj item:[RAMPU]Adjust:[****]PTT : ONPress [ ] key tostore the adjust-ment value.1) Adj item:[Ramp Up Offset]Press [Transmit]button.Press [Apply]button to store theadjustment value.PowermeterAmmeterPanel ANT Panel [Pan-el tun-ingmode][],[][PCtestmode][←],[→][PC test mode][Automatic Adjust-ment]1) Press [Tune RumpOffset] button.2) Press [Apply All] but-ton to store the adjust-ment value after theautomatic adjustmenthas finished.[Manual Adjustment]1) Set the adjustmentvalue to “1”.2) Increase the adjust-ment value slowly whilemonitoring the offsetmonitor value.3) Set the adjustmentvalue when the offsetmonitor value exceed“50”.2.RampdownOffset1) Adj item:[RAMPD]Adjust:[****]PTT : ONPress [ ] key tostore the adjust-ment value.1) Adj item:[Ramp Down Off-set]Press [Transmit]button.Press [Apply]button to store theadjustment value.PowermeterAmmeterPanel ANT Panel [Pan-el tun-ingmode][],[][PCtestmode][←],[→][PC test mode][Automatic Adjust-ment]1) Press [Tune RumpOffset] button.2) Press [Apply All] but-ton to store the adjust-ment value after theautomatic adjustmenthas finished.[Manual Adjustment]1) Set the adjustmentvalue to “1”.2) Increase the adjust-ment value slowly whilemonitoring the offsetmonitor value.3) Set the adjustmentvalue when the offsetmonitor value exceed“20”.3.Hightransmitpower(Batteryvoltage :7.5V)1) Adj item:[An H_PWR]Adjust:[****]2) Adj item:[Low1]→[Low3]→[Center2]→[High1]→[High3]Adjust:[****]PTT : ONPress [ ] key tostore the adjust-ment value.1) Adj item:[High TransmitPower]2) Adj item:[Low1]→[Low3]→[Center2]→[High1]→[High3]Press [Transmit]button.Press [Apply All]button to store theadjustment value.PowermeterAmmeterPanel ANT Panel [Pan-el tun-ingmode][],[][PCtestmode][←],[→]6.0W ±0.1W2.3A or less[PC testmode]Press [ApplyAll] button tostore theadjustmentvalue after alladjustmentpoints havebeen adjusted.
