38Remote SetupChapter Two : Setting Up PowerTouch4. Refer to “Noting Your Devices” on page␣ 3 where younoted which device was connected to which jack set.5. Touch to open the list of available jack sets:• CD1• CD2/TAPE2• MD/TAPE1• CD-R• VIDEO1 through VIDEO4• DVD• AV AUX• TV1 and TV2 (these allow PowerTouch to controlyour TV or cable tuner, even if it isn’t connected toone of the receiver’s input jack sets).Touch the jack name on the list.6. Touch to select the type of device you haveconnected to the jack set.7. Touch to select the device’s brand.8. Touch . You can now choose from a list ofall the codes available for the device. Touch the first codeon the list.• If the devices are connected with a system controlcable, be sure to select the code preceded by “Sys-”or “System”. This instructs PowerTouch to send allcommands for the device to the receiver, which willcontrol the device via the system control cable.• If you have a Kenwood Dual-Play 200-Disc CDChanger, you will need to set both CD1 and CD2/TAPE2 to the correct code for this device (“Sys-Mega”).9. Touch . This instructs PowerTouch to send a“power” test signal to the receiver. If your device turnson, the code you entered was correct. If it does not turnon, try the next code in the list. Continue until one ofthe codes works. If none of the codes work, see “What ifmy device does not work with any of the codes on thelist?” on page␣ 39.If you enter the code preceded by “Sys-” or “System” onstep 8, skip this step.10. When you have a code that works, touch . Checkoff that device on your list.Repeat steps 5 through 10 until you are finished identifyingdevices to PowerTouch. When you are done, turn to “HowDo I Operate Devices?” on page␣ 29 in the Users’ Guide andnote which icon corresponds to which connected device.What if I Connected a CD Player to the JackSet PowerTouch Calls Tape2? (VR-4900/KRF-V9993D only)To set the CD2/Tape2 input for CD:1. Access the Setup menu.2. Touch on the Setup menu to access the Ana-log Input Level menu.3. Touch until CD2 appears in the display.4. Touch to return to the Setup menu.How Do I Replace a Setup Code with a NewOne?If you purchase a new device to replace an existing device,you will need to identify the new device to PowerTouch. Todo so:1. Connect the device as described in the appropriate sectionof Chapter One in this guide.2. Follow the steps under “How Do I Identify Devices?” onpage␣ 37. When you touch, it will replace the other code.How Do I Delete Setup Codes?If you disconnect a device and do not plan to replace it,you may want to delete the setup code from PowerTouch.To do so:1. Follow the steps under “How Do I Identify Devices?” onpage␣ 37 to select a jack set.2. Touch . Scroll to the device “Nothing” thentouch it. That device is no longer controlled byPowerTouch.