Kenwood VR-510 Instruction Manual

Also see for VR-510: Service manual Service manual

Contents

21Preparations1 Display operation 1 keyUse this key to go back to the previous display or initial display.2 Display operation 2 keyGets you into and out of the preset code registration mode.3 DisplayThe information for setup is displayed.4 5/∞ keysUse these keys to select the source or setup code.5 MOVIE, MUSIC, and TV keysUse these keys to select the input you want to register.6 AV POWER keyOnce you have entered the setup code for another component, you canpress this key to turn power to that component on or off. This lets youconfirm that you entered the code properly.How to use the display operation keysTo register the setup code, use the display operation 1 key, displayoperation 2 key, or 5/∞ keys.The display operation 1 key and display operation 2 key work as thefunction key displayed in the display above.The display goes off automatically when you do not operate for more than8 seconds. In this case, press the display operation 1 key, displayoperation 2 key, or 5/∞ keys.When the display goes offPress the display operation 1 key repeatedly until “Menu” appears in thedisplay.The display returns to the initial display.When you are confused about what’s being displayed>06.Cable>05.VCRBack EnterThe display operation 1 key• [Back]Go back to the previous display.• [Home]Go back to the initial display.• [Clr]Erase the internal memory.The display operation 2 key• [Enter]Enter the selected item.• [Menu]Display the menu.• [Setup]Go to the setup display.• [Exit]Exit from the current operation.• [Sel]Select the item.Display operation 1 5/∞Display operation 2DisplaySHIFT MACROMUSICLISTEN M.BASS BOOST SUB W.MUTECH.CH.VOL.VOL.TUNINGBANDENTERAUTO/MONOREC MODEF.SHIFTREC LEARNRANDOMREPEAT INPUT SEL.21 354 687 90+10 +1001110 12DISPLAYTV SELECT SELECTTHEMEAUDIO FAVORITEEXITINFO. LAST CHANNELOSD/PAGERETURN/PAGEDIMMERTITLE/GUIDE MENUSOUND THXMOVIE TVAV POWER SYS. POWERRF REMOTE CONTROL UNITRC-R0812Setting up the systemThe remote control sends an RF (radio wave) signal to the receiver. Forequipment other than the receiver, an IR (Infrared) signal is sent.The remote control supplied with this receiver is also capable of controllingcomponents from a variety of manufacturers once you register the appro-priate setup codes into the remote control unit.Refer to “Remote control operation of other components” for details aboutthe operations available for each component. e