Kenwood VR-510 Instruction Manual

Also see for VR-510: Service manual Service manual

Contents

36Remote Control1Press the display operation 1 key repeatedly until“ Menu” appears in the display.2Press the display operation 2 [Menu] key repeatedly until“ 01.IR” appears in the display.• At this time all inputs become available regardless of any earlierregistration.For step 1 through step @, make sure you start the next stepwithin 8 seconds of completing the previous one. If more than8 seconds elapses between any two steps, press the displayoperation keys so that the display appears.Registering setup codes for other componentsVCRVideo1:Menu• The setup display appears.Press the 5/∞keys to select “ 01.IR”, then press thedisplay operation 2 [Enter] key.• The input selecting display appears.Press the 5/∞keys to select the input that you want toregister.• Each time you press the 5/∞ key, the input changes as follows:01: CD/DVD02: MD/Tape03: Video104: Video205: Video306: DVD07: TV108: TV209: Cable10: Phono34>04.Video2>03.Video1Back Enter>02.Surround>01.IRHome Enter• Example: To select the source connected to the VIDEO1 jack, select“Video1”.Press the display operation 2 [Enter] key.• The source selecting display appears.• When you select “Phono” in step 4, go to step 0.5Press the 5/∞keys to select the source you want toregister.6• Each time you press the 5/∞ key, the input changes as follows:01: CD02: Tape03: MD04: CD-R05: VCR06: Cable07: Satellit08: TV09: LD10: DVD11: DSS12: No type13: Delete• Select “No type” when the desired source does not appear in thedisplay.• The selected input does not appear when you select “Delete”.Press the display operation 2 [Enter] key.• The maker selecting display appears.7Press the 5/∞keys to select the maker you want toregister.8• Press the 5/∞ keys until the desired maker appears in the display.When the desired maker does not appear, select “Nothing”.Press the display operation 2 [Enter] key.• The setup code selecting display appears.9Press the 5/∞keys to select the setup code.0Press the AV POWER key, and check to see that thecomponent you want to control turns on.If the component does not react, and there is more than onesetup code, enter another setup code and try again.• If the component is already on, pressing the AV POWER keywill turn it off.!>06.Cable>05.VCRBack Enter>02:Nothing>01:0056Back Enter>Admidral>KenwoodBack EnterDisplay operation 1 5/∞Display operation 2DisplayRemote control operations