Kenwood VR-510 Instruction Manual

Also see for VR-510: Service manual Service manual

Contents

41Remote Control5 From the remote control unit of the other source, press the keythat you want to store.• When it takes for more than 5 seconds or the remote control unit doesnot receive the remote control code well, “Error” appears in thedisplay. In this case, re-operate from step 1.6 The remote control code is stored on the key of the remotecontrol unit.To delete the memory stored on the keyPress the display operation 1 [Clr] key in step 4. “Cleared”appears in the display.The memory previously stored is cleared.To operate other components1 Press the MUSIC, MOVIE, or TV key to select the desired inputsource.2 Press the desired key.1 Point the infrared ray system part of the other remote controlunit to the remote sensor of the remote control unit .Storing on the memory2 Press the MUSIC, MOVIE, or TV key to select the input of thedesired remote control unit.You can store on the remote control unit up to 5 memories.VCRVideo1:MenuSelected input3 Press the LEARN key.• The Extend selecting display appears.>Extend2>Extend1Home EnterInfrared ray system partRemote controlunit of the othersource.+—+—>Extend1Complete• When the setup code is not registered, any messages do not appear.When the setup code is registered4 Press the 5/∞ keys to select the location.• Extend1 – Extend5 are available.5 Press the display operation 2 [Enter] key.• The remote control is sent for receiving the remote control code.>Extend1WaitingClr Exit6 From the remote control unit of the other source, press the keythat you want to store.• The remote code is sent to the remote control unit.• “Complete” appears when finished.• When it takes for more than 5 seconds or the remote control unit doesnot receive the remote control code well, “Error” appears in thedisplay. In this case, start from the step 1 again.7 The remote control code is stored on the memory (Extend1 –Extend5) of the remote control unit.To operate other components by using the stored memory2 Press the display operation 2 [Menu] key during “Menu” ap-pears in the display.• The Menu display appears.3 Press the 5/∞ keys to select the memory you want to operate.4 Press the display operation 2 [Enter] key.To delete the stored memoryPress the display operation 1 [Clr] key in step 5. “Cleared”appears in the display and the memory that is selected in step 4is erased.1 Press the MUSIC, MOVIE, or TV key to select desired inputsource.>Extend1CompleteExtend 1You can restore the setup codes or memories to their original defaultsettings.• “Cleared” appears in the display, and the remote settings return totheir original default settings.52Insert the batteries while pressing and holding the 5keyand 2key.Restoring the original factory settingsRemote control operations• The remote code is sent to the remote control unit.• “Complete” appears when finished.• To maintain the memory settings, complete the battery replacementoperation approximately within 10 minutes.