Kenwood VR-9080 Instruction Manual

Also see for KRF-X9090D: Service manual Instruction manual

Contents

30 ENRecording music in REC MODE AUTO or MANUAL1 Use the INPUT SELECTOR key or the Input Selector keys to selectthe source (CD/DVD, DVD/6CH, VIDEO 2, VIDEO 3) you want torecord.2 Set the MD or TAPE recorder to record.3 Press and hold the DIMMER key for more than 2 seconds for thefollowing selections;1 REC MODE off2 REC MODE AUTO : The digital input signals (DTS, Dolby Digi-tal, or PCM) are identified automaticallyand converted into stereo signals thatare ready for recording.3 REC MODE MANUAL : The digital input signals (DTS, Dolby Digi-tal, or PCM) are identified and convertedinto stereo signals that are ready forrecording.Once the digital signal is changed toother signal, no signal is output.For REC MODE AUTO :LS SBSL SRC RSP MUTEA B CLIPLFELS SBC RSP MUTEA B CLIPLFESL SRDIGITAL STEREOAUTO DETECTDIGITAL STEREOAUTO DETECTFor REC MODE MANUAL :LSL S SB SRC RLFESP MUTEA B CLIPDIGITAL STEREOLSL S SB SRC RLFESP MUTEA B CLIPDIGITAL STEREO4 Start playback, then start recording.• If the audio reproduction stops in the middle due to change in theinput signals, etc., press the DIMMER key.Recording video1 Use the INPUT SELECTOR key or the Input selector keys to selectthe video source (other than “VIDEO 1”) you want to record.2 Set the video recorder connected to VIDEO 1 to record.• Select the REC MODE to record a digital input source.3 Start playback, then start recording.• Recording may not be normal for some video software. This is dueto the copy guard condition. ERecordingRecording audio (analog sources)Input SelectorkeysINPUTSELECTORRecording a music source1 Use the INPUT SELECTOR key or the Input Selector keys to selectthe source (other than “MD/TAPE”) you want to record.2 Set the MD or TAPE recorder to record.3 Start playback, then start recording.Recording audio (digital sources)Input SelectorkeysINPUTSELECTORDIMMER