Kenwood VR-9080 Instruction Manual

Also see for KRF-X9090D: Service manual Instruction manual

Contents

8 ENMake connections as shown in the following pages.When connecting the related system components, be sureto refer to the instruction manuals supplied with thecomponents you are connecting.Do not connect the power cord to a wall outlet until allconnections are completed.Notes1. Be sure to insert all connection cords securely. If their connectionsare imperfect, sound may not be produced or there will be noise infer-ence.2. Be sure to remove the power cord from the AC outlet before pluggingor unplugging any connection cords. Plugging/unplugging connectioncords without disconnecting the power cord can cause malfunctionsand may damage the unit.CAUTIONDo not connect power cords from components whose powerconsumption is larger than what is indicated on the AC outlet at therear of this unit.Analog connectionsAudio connections are made using RCA pin cords. These cables transferstereo audio signal in an “analog” form. This means the audio signalcorresponds to the actual audio of two channels. These cables usuallyhave 2 plugs on each end, one red for the right channel and one white forthe left channel. These cables are usually packed together with thesource unit, or are available at your local electronics retailer.Microcomputer malfunctionIf operation is not possible or an erroneous display appears, eventhough all connections have been made properly, reset themicrocomputer referring to “In case of difficulty”. ESetting up the system Input mode settingsCD/DVD, VIDEO 2, VIDEO 3 and DVD/6CH inputs each include jacksfor digital audio input and analog audio input.The initial factory settings for audio signal playback for CD/DVD,DVD/6CH, VIDEO 2 and VIDEO 3 are “FULL AUTO”.After completing connections and turning on the receiver, follow thesteps below.INPUT MODEINPUTSELECTORInput SelectorkeysINPUT MODE1 Use the INPUT SELECTOR key or Input Selector keys to selectCD/DVD, VIDEO 2, VIDEO 3 or DVD/6CH.2 Press the INPUT MODE key.Each press switches the setting as follows:In DTS play mode1 FULL AUTO (digital input, analog input)2 DIGITAL MANUAL (digital input)In CD/DVD, VIDEO 2, VIDEO 3 or DVD/6CH play mode1 FULL AUTO (digital input, analog input)2 DIGITAL MANUAL (digital input)3 6CH INPUT (DVD/6CH input only)4 ANALOG (analog input)Auto detect:In FULL AUTO mode ("AUTO DETECT" indicator lights up), thereceiver detects the digital or analog input signals automatically.The receiver will select the input mode and listening mode auto-matically during playback to match the type of input signal (DolbyDigital, PCM, DTS) and the speaker setting. flThe "DIGITAL" indicator lights up when a digital signal isdetected. The "DIGITAL" indicator is extinguished when nodigital signal is detected.Fixed to digital input:Select this mode if you want to keep the decoding condition (DolbyDigital, DTS, PCM, etc.) in the current listen mode.When DIGITAL MANUAL mode is selected, the set listen modesmay be changed automatically depending on the input signal. flFixed to analog input:Select this setting to play analog signals from a VCR, etc.If the INPUT MODE key is pressed quickly, sound may not beproduced. Press the INPUT MODE key again.Memory back up functionPlease note that the following items will be deleted from the unit'smemory if the power cord is disconnected from the AC outlet forapproximately 1 day.• Power mode• Input selector settings• Speaker ON/OFF• Volume level• BASS, TREBLE, INPUT level• TONE ON/OFF• LOUDNESS ON/OFF• Dimmer level• Listen mode setting• Speaker settings• Input mode setting• Sound mode settings• Broadcast band• Frequency setting• Preset stations• Tuning mode• ACTIVE EQ mode• GAME mode setting