Kenwood VR-9080 Instruction Manual

Also see for KRF-X9090D: Service manual Instruction manual

Contents

38 ENAmbience effectsVirtual modesThe following modes allow you to enjoy astonishing ambience effecteven when you use only two speakers or listen through headphones.• In the Dolby Virtual Speaker and Dolby Headphone modes, the desiredlisten mode may be unable to be selected depending on the reproducedsignals. flDOLBY VIRTUALPHONESDOLBY VIRTUALHow to set the Dolby Virtual Speaker mode(when not using headphones):Press the DOLBY VIRTUAL key for the following selections:1 DOLBY VS WIDE : The virtual surround effect can be given addedexpansion and spatial feeling.(DOLBY VS indicator lights up)2 DOLBY VS REF : Standard setting.*(DOLBY VS indicator lights up)3 DOLBY VS OFF : Cancel(DOLBY VS indicator goes off)* This mode can be selected only when the surround speaker settingis OFF.How to set the Dolby Headphone mode(when using headphones):Press the DOLBY VIRTUAL key for the following selections:1 DOLBY H DH 1 : Monitor room in a studio with small amountof reverberations.(DOLBY H indicator lights up)2 DOLBY H DH 2 : General listening with optimum amount ofreverberations.(DOLBY H indicator lights up)3 DOLBY H DH 3 : Wide space such as a movie theater.(DOLBY H indicator lights up)4 DOLBY H OFF : Cancel(DOLBY H indicator goes off)• The Dolby Virtual Speaker mode will be available when the SPEAKERSA is ON and SPEAKERS B is OFF.• Dolby Virtual Speaker is effective for sampling frequencies of 32kHz,44.1kHz and 48kHz. Dolby Headphone is effective for sampling fre-quencies of 44.1kHz and 48kHz.DVD 6-channel playbackUsing a DVD player or the like equipped with six (5.1) output channels andthe receiver, you can enjoy surround sound playback.INPUT MODE VOLUME CONTROLINPUT SELECTORPreparations• Connect your DVD player to the DVD/6CH jacks of the receiver.0• Turn on all other components that will be used.• Complete “Preparing for surround sound”. )1Use the INPUT SELECTOR key or DVD/6CH key to select“DVD/6CH” as the input source.2Select "6CH INPUT" by pressing the INPUT MODE key.• If speaker system B is on when “6CH INPUT” is selected as theinput mode, it switches off and speaker system A turns onautomatically.• The indication "6CH INPUT" appears in the display during DVD 6-channel mode selection.3Start playback of the DVD software.4Adjust the volume.Notes• It is not possible to adjust the sound quality (SETUP, SOUND,LISTEN MODE, ACTIVE EQ, THX, STEREO, DSP MODE, LOUD-NESS and TONE key will not be functional) of the channelsseparately when the receiver is in the 6CH INPUT mode. Adjust thevolume with the controls of the DVD player.For the powered subwoofer, you can adjust the volume of thesubwoofer using the subwoofer’s own volume control.