114 Keysight E8402A, E8404A C-Size Mainframes User and Service GuideProgramming the Enhanced Monitor STATus SubsystemSTATus:PRESetThe STATus:PRESet command sets the enable registers. The Operation andQuestionable Enable Registers are preset to 0, disabling all events. All otherenable registers are preset to 1s (except P5STBY and P5EXT in theSTAT:QUES:VOLT:ENABle register), enabling all events. The SCPI positivetransition filters are preset to 1s.Comments– After executing this command, none of the events in the OPERation eventregister or the QUEStionable event register will be reported as a summarybit in the Status Byte.– This command does not clear or change any of the Events in theOPERation status group or the QUEStionable status group.– If *PSC was set to 0 prior to power-down, then at power-on, the enableregisters are loaded from non-volatile memory. Therefore, any values thatyou have stored (SYSTem:NVSave command) are returned to the registers.However, if *PSC was set to 1, then at power-on the factory defaults arereturned. The factory defaults are listed in the following table:Reset Condition*RST does not affect the status system.Related CommandsSTATus:OPERation:ENABle, STATus:QUEStionable:ENABle,STATus:QUEStionable:BLOWer:ENABle, STATus:QUEStionable:CURRent:ENABle,STATus:QUEStionable:TEMPerature:ENABle,STATus:QUEStionable:VOLTage:ENABleRegister DefaultValueSTATus:OPERation:ENABle 0STATus:QUEStionable:ENABle 0STAT:QUES:BLOWer:ENABle 7STAT:QUES:CURRent:ENABle 487STAT:QUES:TEMPerature:ENABle 32767STAT:QUES:VOLT:ENABle 487STAT:QUES:VOLT:PTR 511
