42.1.1 Wall-Mounting the TPSD (4B, 4 and 9 Cases Only)The 4B, 4 and 9 cases of the TPSD are shipped from the factory with the necessary brackets installed for wall-mounting(The same bracket is used for rear mounting on a relay rack, 4B and 4 – 19/23” rack, 9 – 23/30”rack) The 72 & 44 cases do not come with wall mounting equipment, it is not recommended to attempt tomount these cases on any wall.Wall-Mount ProcedureTo wall-mount the TPSD, install four 0.5 in (12.7 mm) bolts on the wall rated to support the charger weight plusa safety factor of at least two times. Place the TPSD on the bolts, add appropriate mounting hardware andtighten. Refer to the figures below for mounting dimensions and specifications.NOTE: All above dimensions are in inches. For further TPSD cabinet information, see the outline drawings forthe 4B case (4B, 4B-23) 4 case (4, 4_23) and 9 case (9, 9_30) online athttp://www.lamarchemfg.com/info/enclosure-drawings.htmlFigure 5 - 9 Case Bolt PatternFigure 3 - 4B Case Bolt PatternFigure 4 - 4 Case Bolt Pattern
