Lantronix WiPort User Manual

Also see for WiPort: Integration guide User guide Quick start guide

Contents

Lantronix WiPort User Manual Manual pdf 31 page image

4: Configuration Using Web ManagerWiPort Embedded Wireless Device Server User Guide 31Port SettingsProtocol Select the protocol type from the pull down menu for theselected channel.Flow Control Flow control manages data flow between devices in a networkto ensure it is processed efficiently. Too much data arrivingbefore a device is prepared to manage it causes lost orretransmitted data. None is the default. Channel 1: None, Xon/Xoff, Xon/Xoff Pass Chars to Hostor CTS/RTS (hardware). Channel 2: None, Xon/Xoff or Xon/Xoff Pass Chars toHostBaud Rate The unit and attached serial device, such as a modem, mustagree on a speed or baud rate to use for the serial connection.Valid baud rates are 300, 600, 1200, 2400, 4800, 9600(default), 19200, 38400, 57600, 115200, 230400, 460800, or921600.Data Bits Indicates the number of bits in a transmitted data package.Parity Checks for the parity bit. The default is None.Stop Bits The stop bit follows the data and parity bits in serialcommunication. It indicates the end of transmission.Pack ControlEnable Packing Select the checkbox to enable packing on the WiPort.Two firmware-selectable packing algorithms define how andwhen packets are sent to the network. The standard algorithmis optimized for applications in which the unit is used in a localenvironment, allowing for very small delays for singlecharacters, while keeping the packet count low. The alternatepacking algorithm minimizes the packet count on the networkand is especially useful in applications in a routed Wide AreaNetwork (WAN). Adjusting parameters in this mode caneconomize the network data stream.Idle Gap Time Select the maximum time for inactivity. The default time is 12milliseconds.Match 2 Byte Sequence Use to indicate the end of a series of data to be sent as onegroup. The sequence must occur sequentially to indicate tothe WiPort end of the data collection.Match Bytes Use to indicate the end of a series of data to be sent as onegroup. Set this value to 00 if specific functions are not needed.Send Frame Immediate After the detection of the byte sequence, indicates whether tosend the data frame or the entire buffer. Select Yes to sendonly the data frame. The default setting is No.Send Trailing Bytes Select the number of bytes to send after the end-of-sequencecharacters.Flush Input Buffer (Serial to Network)With Active Connect Select Yes to clear the input buffer with a connection that isinitiated from the device to the network.