Lantronix WiPort User Manual

Also see for WiPort: Integration guide User guide Quick start guide

Contents

Lantronix WiPort User Manual Manual pdf 61 page image

6: Configuration via Serial Mode or Telnet PortWiPort Embedded Wireless Device Server User Guide 61Table 5-14. Pack Control OptionsOption 7 6 5 4 3 2 1 0Packing IntervalInterval: 12ms 0 0Interval: 52ms 0 1Interval: 250ms 1 0Interval: 5sec 1 1Trailing CharactersNone 0 0One 0 1Two 1 0Send Characters2-Byte Send CharacterSequence 1Send Immediately AfterSend chars 1Packing Interval: Packing Interval defines how long the unit should wait beforesending accumulated characters. This wait period is between successive networksegments containing data. For alternate packing, the default interval is 12 ms.Trailing Characters: In some applications, CRC, Checksum, or other trailingcharacters follow the end-of-sequence character; this option helps to adapt frametransmission to the frame boundary.Send Characters: If 2-Byte Send Character Sequence is enabled, the unit interprets thesendchars as a 2-byte sequence; if this option is not enabled, the unitinterprets them independently. If Send Immediately After Characters is not set, any characters already inthe serial buffer are included in the transmission after a "transmit" condition isfound. If this option is set, the unit sends immediately after recognizing thetransmit condition (sendchar or timeout).Note: A transmission might occur if status information needs to beexchanged or an acknowledgment needs to be sent.DisConnTime (Inactivity Timeout)Use this parameter to set an inactivity timeout. The unit drops the TCP connection toport 10001/10002* if there is no activity on the serial line before the set time expires.Enter time in the format mm:ss, where m is the number of minutes and s is thenumber of seconds.Note*: The default port number for Port 1 is 10001 and 10002 for Port 2. However,port numbers may be set to a different value.DisConnTime (0: 0) ?: