6: Configuration via Serial Mode or Telnet PortWiPort Embedded Wireless Device Server User Guide 75Channel 2 ConfigurationBaudrate 9600I/F Mode 4C (1 stop bit, no parity, 8 bit, RS-232C, no flowcontrol)Port No 10002Connect Mode C0 (always accept incoming connection; no activeconnection startup)Hostlist Retry Counter 3Hostlist Retry Timeout 250 (msec)Send Character 0x0D (CR)All other parameters 0WLAN SettingsTopology 1 (AdHoc)Network Name LTRX_IBSSChannel 11Security 0 (none)TX Data Rate1 54 MbpsTX Data Rate Auto Fallback1 1 (auto fallback)Minimum TX Data Rate1 1 MbpsMax TX Failures 1 6 (failed attempts)Enable Power Management1 N (No)Enable Soft AP Roaming N (No)Expert SettingsTCP Keepalive 45 (seconds)ARP Cache Timeout 600 (seconds)CPU Performance RegularDisable Monitor Mode N (No)1 This is included in the 7 Defaults menu reset. To reset the other WLAN settings, use one of the“Reset to Defaults” Configurable Pin Settings. For more information on Configurable Pins, seeConfigurable Pins on page 80.
